by | Aug 5, 2026
DIRECTIONS Carefully unscrew the cap. Brush on Plastic-Cure™ to one surface of the parts being joined, then hold parts tightly together for 10-20 seconds. Plastic-Cure™ won’t frost clear plastic and works on white foam.
by | Aug 5, 2026
Un-cure deboned will soften cured ca. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened ca, then wash off with soap and water. Since cured ca is essentially acrylic plastic, anything that will dissolve ca will also soften most...
by | Aug 5, 2026
This is a One ounce bottle of Bob Smith Industries INSTA-CURE+ Gap Filling CA Glue. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds.
by | Aug 5, 2026
Insta-Cure has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam.
Recent Comments