by | Aug 5, 2026
Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used.
by | Aug 5, 2026
Ideal for fast CA setting in joints. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. For difficult to bond materials, INSTA-SET can be applied to one surface and CA to the opposite surface.
by | Aug 5, 2026
SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of our epoxies. It is waterproof and more heat resistant. SLOW-CURE™ can be used for bonding if you’re willing to wait overnight.
by | Aug 5, 2026
by | Aug 5, 2026
Bob Smith Industries BSI-162 DEBONDER CA-Remover. Un-cure deboned will soften cured ca. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened ca, then wash off with soap and water.
Recent Comments